2025-03-12

FRONT LICENSE PLATE BRACKET - CHINA (Remove and Replace)

Correction code 1207010202 FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: FRONT LICENSE PLATE BRACKET - CHINA (Remove and Replace) /
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x4) that secure the front license plate bracket
0.8 Nm (7 lbs-in)
  • DRIVER KIT, 1/4" HEX, M12
  • ¼ in hex to ¼ in square 2 in adapter
  • 8 mm socket
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the screws (x4) that secure the front license plate bracket.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • DRIVER KIT, 1/4" HEX, M12
    • ¼ in hex to ¼ in square 2 in adapter
    • 8 mm socket
    • Ratchet/torque wrench

Install

  1. Install the screws (x4) that secure the front license plate bracket.
    0.8 Nm (7 lbs-in)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not over torque the screws. Pay attention to the installation position.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • DRIVER KIT, 1/4" HEX, M12
    • ¼ in hex to ¼ in square 2 in adapter
    • 8 mm socket
    • Ratchet/torque wrench