Carrier - Side Shield - Inboard - LH (Remove and Replace)
Correction code
TBD
FRT
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH front seat inboard side shield. See 1ST ROW INBOARD SIDESHIELD - LEFT HAND (Remove and Replace).
- Remove the inboard side shield carrier front clips (x2) from the LH front seat.
-
Partially lift the inboard side shield
carrier upper shroud from the LH front seat.
NoteDon't use too much force to prevent damage to the carrier and the trim.
-
Remove the inboard side shield carrier
from the LH front seat.
NotePull the carrier backward to release the positioning clips.
Install
-
Install the inboard side shield
carrier to the LH front seat.
NotePush the carrier forward to fix the positioning clips to the seat.
-
Press the inboard side shield carrier
upper shroud into the LH front seat.
NoteAdjust the carrier as needed. Use caution not to damage the carrier and the trim.
- Install the inboard side shield carrier front clips (x2) to the LH front seat.
- Install the LH front seat inboard side shield. See 1ST ROW INBOARD SIDESHIELD - LEFT HAND (Remove and Replace).