2025-03-12

HARNESS - FRONT LEFT HAND DOOR - PREMIUM - LEFT HAND DRIVE (Remove and Replace)

Correction code 1710030502 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH front door moving side glass. See MOVING SIDE GLASS - FRONT DOOR - LEFT HAND (Remove and Replace).
  2. Disconnect the LV battery power. See LV Power (Disconnect and Connect).
  3. Use a small flat head screwdriver to disconnect the LH exterior mirror connector, and then release the clip that attaches the LH exterior mirror harness to the closeout panel.
  4. Release the connector lock, and then disconnect the LH front door pressure sensor electrical connector.
  5. Disconnect the LH front regulator motor connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Disengage the red locking tab, and then press down the black tab to release the connector.
  6. Remove the LH front door speaker woofer. See Speaker - Front Door (Remove and Replace).
  7. Remove the LH front door closeout panel assembly. See WINDOW REGULATOR CLOSEOUT FRONT DOOR - LEFT HAND (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    No need to remove the door pressure sensor, the window regulator motor, and the window regulator from the door closeout panel assembly.
  8. Disconnect the LH front door handle connector.
  9. Disconnect the LH front door electrical harness from the LH front door latch connector.
  10. Remove the LH lower A-pillar trim. See A PILLAR LOWER TRIM - LEFT HAND (Remove and Install).
  11. Release the LH front door harness along the door side.
  12. Disconnect the J7 front door connector from the LH body controller.
  13. Remove the LH front door harness from the door assembly.

Install

  1. Make sure the seal is fully seated around the black grommet, and then route the LH front door harness through the outer A-pillar.
  2. Connect the J7 door connector to the LH body controller.
  3. Secure the LH front door harness along the door side.
  4. Install the LH lower A-pillar trim. See A PILLAR LOWER TRIM - LEFT HAND (Remove and Install).
  5. Connect the LH front door latch connector.
  6. Connect the LH front outer door handle connector.
  7. Install the LH front door closeout panel assembly. See WINDOW REGULATOR CLOSEOUT FRONT DOOR - LEFT HAND (Remove and Replace).
  8. Install the LH front door speaker woofer. See Speaker - Front Door (Remove and Replace).
  9. Install the LH exterior mirror harness.
  10. Connect the LH front regulator motor connector.
  11. Connect the LH front door pressure sensor connector.
  12. Connect the LV battery power. See LV Power (Disconnect and Connect).
  13. Install the LH front door moving side glass. See MOVING SIDE GLASS - FRONT DOOR - LEFT HAND (Remove and Replace).
  14. Install the glass run seal clip to the LH front door assembly.
  15. Install the HEPA filter assembly. See HEPA FILTER (Remove and Replace).
  16. Move the LH front seat to original position.
  17. Raise the LH front window and close the LH front door.