2026-03-31

Cover - Camera - Rear Facing (Remove and Install)

Correction code 1722040501 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-03-31: Added information to skip camera calibration.

Remove

  1. Remove the rear facing camera from the camera cover. See Camera - Rear Facing (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not disconnect the rear facing camera for this procedure.

Install

  1. Install the rear facing camera to the camera cover. See Camera - Rear Facing (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    Skip the instructions for Service Mode and Clear Camera Calibration if the camera was not disconnected for this procedure.