HVAC - Thermistor Duct-RH (Remove and Replace)
Correction code
1810010902
FRT
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Remove the RH footwell hush panel. See Hush Panel - Footwell - Front Passenger (Remove and Replace).
-
Disconnect the RH instrument panel air
wave duct thermistor connector.
-
Release the tabs (x2) that attach the
RH air wave duct thermistor to the duct assembly, and then remove the thermistor from
the assembly.
Install
-
Secure the tabs (x2) that attach the RH air wave duct thermistor to the duct
assembly.
-
Connect the RH instrument panel air wave duct thermistor connector.
- Install the RH footwell hush panel. See Hush Panel - Footwell - Front Passenger (Remove and Replace).