2025-03-12

HEPA And Carbon Filters (Remove and Replace)

Correction code 1810011502 FRT 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Install

  1. Install the HEPA filters.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pay attention to the installation direction.
  2. Install the carbon filters. See Carbon Filter (Remove and Replace).
  3. Place the vehicle in Service Mode by using the touchscreen. See Service Mode.
  4. Unlock the vehicle gateway. See Gateway (Unlock).
  5. On the touchscreen, tap the Service Mode "wrench" (at the bottom of the touchscreen UI), and then tap Thermal > HVAC > Right > HEPA Filter Health > Reset HEPA Filter Score > Run, and allow the routine to complete. Select Close to close the window once the routine is complete, and verify the HEPA Filter Health has been reset to 100%.
  6. Exit Service Mode. See Service Mode.
  7. Raise the LH front window and close the LH front door.