2026-03-11

Assembly - Trailer Hitch (ECE) (Remove and Replace)

Correction code 1230010202 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  1. 2026-03-11: Updated image of trailer hitch harness. Added instruction to tuck the harness under the bumper beam.
  2. 2025-10-14: Added software reinstall step.

Torque Specifications

Table 1. Torque Specifications: Assembly - Trailer Hitch (ECE) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nuts (x6) that attach the bumper beam to the trailer hitch body
62.5 Nm (46.1 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • 15 mm deep socket
  • Flex head ratchet/flex head torque wrench
 Reuse

Remove

  1. Remove the rear fascia assembly. See Assembly - Fascia and Diffuser - Rear (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    When performing this repair via Mobile Service, only partially remove the rear fascia. See Fascia Assembly - Rear - Partially Remove (Mobile Only) (Remove and Install).
  2. Disconnect the trailer hitch harness connector.
  3. Remove the nuts (x6) that attach the bumper beam to the trailer hitch body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 15 mm deep socket
    • Flex head ratchet/flex head torque wrench
  4. With assistance, remove the trailer hitch assembly from the body studs.

Install

  1. With assistance, install the trailer hitch assembly to the body studs.
  2. Install the nuts (x6) that attach the bumper beam to the trailer hitch body.
    62.5 Nm (46.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 15 mm deep socket
    • Flex head ratchet/flex head torque wrench
  3. Connect the trailer hitch harness connector and tuck the harness underneath the bumper beam.
  4. Install the rear fascia assembly. See Assembly - Fascia and Diffuser - Rear (Remove and Install).
  5. Reinstall the vehicle software. See Software Reinstall - Touchscreen.