INSTRUMENT PANEL - AIR WAVE DUCT - LEFT HAND (Remove and Replace)
Correction code
1405030602
FRT
1.15
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
-
Remove the instrument panel upper assembly. See Assembly - Instrument Panel - Upper (Remove and Replace).
NoteJust remove the assembly from the vehicle. Do not remove attached components, such as the defrost ducts, air vents, instrument panel trim harness, and the front passenger airbag, from the upper assembly.
- Release the LH instrument panel air wave duct push clips (x2).
- Disconnect the LH air wave duct connector, and remove the duct from the vehicle.
Install
- Position the LH air wave duct into the vehicle, and connect the connector.
- Install the LH instrument panel air wave duct push clips (x2).
- Install the instrument panel upper assembly. See Assembly - Instrument Panel - Upper (Remove and Replace).