2025-03-12

FRONT CHECK STRAP (Remove and Replace)

Correction code 1133010502 FRT 0.25 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1454796-00-A TOOLKIT, WINDOW SWITCH

Torque Specifications

Table 1. Torque Specifications: FRONT CHECK STRAP (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the LH front door check strap to the body
24 Nm (17.7 lbs-ft)
  • Torx T40 socket
Reuse
Nuts (x2) that attach the LH front door check strap to the LH front door
10 Nm (7.4 lbs-ft)
  • 10 mm socket
Reuse

Remove

  1. Remove the LH front door speaker. See Speaker - Front Door (Remove and Replace).
  2. Connect the window switch tool to the LH front door electrical harness, and then raise the LH front window.
  3. Remove the bolt that attaches the LH front door check strap to the body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 socket
  4. Remove the nuts (x2) that attach the LH front door check strap to the LH front door.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Reach inside the door opening and remove the check strap from the door.

Install

  1. Position the check strap through the door opening.
  2. Install the bolt that attaches the LH front door check strap to the body.
    24 Nm (17.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 socket
  3. Install the nuts (x2) that attach the LH front door check strap to the LH front door.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Lower the LH front window fully.
  5. Disconnect the window switch tool.
  6. Remove the LH front door speaker. See Speaker - Front Door (Remove and Replace).