2025-03-12

Pivot Clamp - Center Seatback - 2nd Row (5-Seat) (Remove and Replace)

Correction code 1305030702 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the center 2nd row lumber bun. See Lumbar Bun - Center - 2nd Row (Remove and Replace).
  2. Remove the bolts (x2) that attach the pivot bracket clamps to the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T45 socket
  3. Slide the pivot bracket clamps towards the center of the 2nd row center seat frame, and then remove the clamps from the vehicle.

Install

  1. Insert the pivot clamp at the center of the center frame, then slide the clamps outwards to both ends of the frame.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the clamps are properly positioned and aligned for fastener installation.
  2. Install the bolts (x2) that attach the pivot bracket clamps to the seat assembly.
    22 Nm (16.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T45 socket
  3. Install the center 2nd row lumber bun. See Lumbar Bun - Center - 2nd Row (Remove and Replace).