2025-03-12

ANTENNA-AMPLIFIER - FM/DAB (Remove and Replace)

Correction code 2130010202 FRT 0.10 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Table 1. Torque Specifications: ANTENNA-AMPLIFIER - FM/DAB (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the tuner to the body
4 Nm (2.9 lbs-ft)
  • 10 mm deep socket
Reuse

Remove

  1. Remove the liftgate upper trim. See LIFTGATE UPPER TRIM (Remove and Replace).
  2. Disconnect the electrical connectors (x2) from the FM/DAB antenna amplifier.
  3. Remove the bolt that attaches the FM/DAB antenna amplifier to the body, and then remove the amplifier from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket

Install

  1. Position the FM/DAB antenna amplifier to the vehicle, and then install the bolt that attaches the amplifier to the body.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
  2. Connect the electrical connectors (x2) to the FM/DAB antenna amplifier.
  3. Install the liftgate upper trim. See LIFTGATE UPPER TRIM (Remove and Replace).