2025-03-11

Fascia Bracket - Headlight - LH (Remove and Replace)

Correction code 1740020402 FRT 0.55 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Fascia Bracket - Headlight - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x4) that attach the LH headlight bracket to the body
1.8 Nm (1.3 lbs-ft)
  • Torx T25 socket
Reuse

Remove

  1. Remove the front fascia assembly. See FRONT FASCIA (Remove and Install).
  2. Remove the screws (x4) that attach the LH headlight bracket to the body, and then remove the bracket from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    There are 4 rubber pads on the back of the bracket.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket

Install

  1. Install the screws (x4) that attach the LH headlight bracket to the body.
    1.8 Nm (1.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Before installation, make sure that the 4 rubber pads are present on the back of the bracket.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  2. Install the front fascia assembly. See FRONT FASCIA (Remove and Replace).