2025-10-28

Lumbar Bun - Center - 2nd Row (Remove and Replace)

Correction code 1305010202 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Lumbar Bun - Center - 2nd Row (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut secures center seatback lumbar bun
2.2 Nm (1.6 lbs-ft)
  • Torx T20 bit
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the 2nd row seat center backpanel. See 2nd Row - Backpanel - Center (Remove and Replace).
  2. Remove center seatback lumbar bun fastener.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Ratchet/torque wrench
  3. Fold 20 seatback in up position.
  4. Release the clip that attaches the handle cable to the seat frame, and then remove the 2nd row LH seat back handle assembly from the seat frame.

Install

  1. Install center seatback lumbar bun.
  2. Fold 20 seatback in down position.
  3. Install center seatback lumbar bun fastener.
    2.2 Nm (1.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Ratchet/torque wrench
  4. Install the 2nd row seat center backpanel. See 2nd Row - Backpanel - Center (Remove and Replace).