2026-04-29

Trunk Side Trim - LH (7-Seat) (Remove and Replace)

Correction code 1530051202 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open the LH front and rear doors and lower the windows.
  2. Move the LH front seat forward.
  3. Move the 60 seat to the easy entry position.
  4. Partially remove the LH rear primary door seal from the vehicle body.
  5. Release the clips (x8) that attach the LH lower C-pillar trim.
  6. Open the liftgate.
  7. Release the 3rd row LH and RH seat backrests.
  8. Remove the rear load floor. See Trunk Load Floor - Rear (Remove and Replace).
  9. Remove the trunk sill trim. See Trunk Sill Lower Trim (Remove and Replace).
  10. Remove the LH load floor bracket.
  11. Remove the LH trunk pocket bracket. See Pocket Bracket - LH (7-Seat) (Remove and Replace)
  12. Release the clips (x11 and location pins (x2) that attach the LH trunk side trim to the body, and then disconnect the electrical connector before removing the LH trunk side trim.

Install

Installation procedure is the reverse of removal.