2026-09-15

Cover - Wheel - Front - LH (Remove and Replace)

Correction Code 34015022 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-09-15: Added a detailed description of how to remove the cover.
  • 2025-12-15: Added inspection for debris and pull test steps to Installation section. Added additional images and detail.
  • 2025-04-10: Added additional notes and images regarding proper wheel trim installation.

Remove

  1. Remove the wheel cover from the wheel.
    1. Carefully insert the L-shaped plastic trim tool into the gap between the wheel cover and the wheel to release the spring clip.
      Note
      See pry locations marked in red in the figure.
    2. Work around to release all the clips.
    3. Release the center ring, and then remove the wheel trim from the wheel.

Install

  1. Ensure that the wheel and hub surface are clean and free of debris.
  2. Align the valve stem with the hole in the wheel cover.
  3. Press the center of the wheel cover over the hub to engage the center ring.
  4. Apply even pressure around the perimeter of the cover. Press firmly until the clips (x5) click into place.
    Note
    An improperly installed wheel trim can cause excess road noise.
  5. Pull the wheel cover to verify that the cover is firmly attached.
    Note
    Make sure the center ring and all surrounding clips are fully and securely seated on the wheel, and that there are no gaps between the wheel trim and wheel spokes.
    Figure 1. Make sure there are no gaps (highlighted red)