2026-08-09

Door Trim - Rear - LH (Remove and Replace)

Correction code 1513020702 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-06-09: Updated routines to use service UI.

Replace

  1. Install the LH rear door trim panel. See Door Trim - Rear - LH (Remove and Install).
  2. Enable Service Mode. See Service Mode.
  3. Unlock the gateway. See Gateway (Unlock).
  4. Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox (Connect and Disconnect).
  5. Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): PROC_VC_X_RGB-LIGHTS-ADDRESSINGvia Service Mode:
    • Low Voltage ➜ Interior Lighting ➜ Address RGB Lights
    • Mid Voltage ➜ Interior Lighting ➜ Address RGB Lights
    via Toolbox:(link)
  6. Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
  7. On the touchscreen, press and hold the Exit Service Mode button to exit Service Mode.