2025-03-20

Module - Ambient Light - Rear Door (Remove and Replace)

Correction code 1513111402 FRT 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Install

  1. Install the rear door ambient light module. See Module - Ambient Light - Rear Door (Remove and Install).
  2. Place the vehicle in Service Mode by using the touchscreen. See Service Mode.
  3. Unlock the vehicle gateway. See Gateway (Unlock).
  4. On the touchscreen, tap the Service Mode "wrench" (at the bottom of the touchscreen UI), and then tap Low Voltage > Interior Lighting > Address RGB Lights > Run, and allow the routine to complete.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the vehicle firmware is version 2024.44 or later.
  5. Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
  6. Exit Service Mode. See Service Mode.