2026-08-09

Seat Cushion - 2nd Row (Remove and Replace)

Correction code 1305010602 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open all doors and lower all windows.
  2. Move the driver seat and the front passenger seat fully forward.
  3. Lift the front edge of the seat cushion upward to release the foam from the frame, and then disconnect the harness connector.
  4. Remove the 2nd row seat cushion from the vehicle.

Install

  1. Connect the harness connector, and then slide the 2nd seat cushion rearward to install it into position.
    Note
    Align the foam with the seat rail.
    Note
    Perform a push-pull-push test to make sure that the cushion is fully secured.
  2. Insert the seat belt buckles through the seat cushion holes.
  3. Move the driver seat and the front passenger seat to their original position.
  4. Raise all windows and close all doors.