Active Grille Shutter (Remove and Replace)
Correction code
1001040102
FRT
0.6
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the active grill shutter. See Active Grille Shutter (Remove and Install).
Install
- Install the active grill shutter. See Active Grille Shutter (Remove and Install).
- Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
- In Toolbox, click the Actions tab, type "PROC_VCFRONT_X_LOUVER-CALIBRATION" into the search field, and select PROC_VCFRONT_X_LOUVER-CALIBRATIONvia Toolbox: (link), and then click Run to allow the routine to complete.
- In Toolbox, click the Actions tab, type "TEST-SELF_VCFRONT_X_HEAT-PUMP-THERMAL-PERFORMANCE" into the search field, and select TEST-SELF_VCFRONT_X_HEAT-PUMP-THERMAL-PERFORMANCE, and then click Run to allow the routine to complete.
- Disconnect the laptop from the vehicle.
- Exit Service Mode. See Service Mode.
- Raise the LH front window and close the LH front door.