2024-12-24

Sensor - Exterior Door Handle - Front - LH (Remove and Replace)

Correction code TBD FRT 0.5 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH front door closeout panel assembly. See WINDOW REGULATOR CLOSEOUT FRONT DOOR - LEFT HAND (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the LH front door pressure sensor, window motor, door speaker and the window regulator from the door closeout panel assembly.
  2. Disconnect the LH front door handle connector.
  3. Remove the screws (x2) that attach the LH front door handle sensor to the door panel, and then remove the sensor from the handle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the LH front door handle sensor to the vehicle, and then install the screws (x2) that attach the sensor to the handle.
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Connect the LH front door handle connector.
  3. Install the LH front door closeout panel assembly. See WINDOW REGULATOR CLOSEOUT FRONT DOOR - LEFT HAND (Remove and Replace).