2026-08-09

Accelerometer - B-Pillar - LH (Model YL) (Remove and Replace)

Correction code 20200100302 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Table 1. Torque Specifications: Accelerometer - B-Pillar - LH (Model YL) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the LH B-pillar accelerometer sensor to the body
10 Nm (7.4 lbs-ft)
  • 10 mm socket
 Reuse

Remove

  1. Disconnect LV battery. See LV Power (Disconnect and Connect) (Modify).
  2. Remove the B-pillar lower trim. See Trim - B-Pillar - Lower - LH (Model YL) (Remove and Replace).
  3. Disconnect the electrical connector from the LH B-pillar accelerometer sensor.
    Note
    Pull the red tab away to disengage the lock, then pull to disconnect the connector.
  4. Remove the bolt that attaches the LH B-pillar accelerometer sensor to the body, then remove the sensor.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket