Rocket Bracket - LH (Remove and Install)
Correction code
1220020901
FRT
0.18
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Remove LH rear fender garnish from vehicle. See Fender Garnish - Rear - LH (Remove and Replace).
- Remove LH rocker cover from rocker carrier. See Rocker Cover - LH (Remove and Replace).
-
Remove LH rear rocker bracket from vehicle.
-
Clean double sided tape residue off LH side of body and rocker bracket.
-
Stick 3M tape on the bracket.
Install
-
Remove adhesive backing from LH rear
rocker bracket.
-
Align tab on bracket onto lower hole
of LH rear fender and rotate bracket towards front of vehicle engaging lip of bracket to
body, and then press bracket down to adhere rocker bracket onto body.
- Install LH rocker cover to rocker carrier. See Rocker Cover - LH (Remove and Replace).
- Install LH rear fender garnish to vehicle. See Fender Garnish - Rear - LH (Remove and Replace).