2025-10-02

Harness - Front End Module (Model Y Standard) (Remove and Replace)

Correction code TBD FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.NOTE: See Ergonomic Precautionsfor safe and healthy working practices.

Remove

  1. Remove the HEPA filter or cowl assembly. See HEPA Filter Assembly (Remove and Replace) or Cowl Assembly (Model Y Standard) (Remove and Replace).
  2. Disconnect the LV power. See LV Power (Modify).
  3. Disconnect the hood latch actuator connector.
  4. Disconnect the hood latch connector.
  5. Disconnect the active grille shutter actuator electrical connector.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not push down on the red tab. Pull the red tab to release the connector lock.
  6. Disconnect the LH and RH front end carrier harness connectors (x2).
  7. Disconnect the LH and RH accelerometer sensor connectors (x2).
  8. Remove the ambient air temperature sensor connector. See Sensor - Ambient Air Temperature - Heating/Cooling Circuit (Remove and Replace).
  9. Release the front end carrier harness clips (x6) and remove the harness.

Install

  1. Position the harness into the vehicle and secure the harness clips (x6) to the front end carrier.
  2. Install the ambient air temperature sensor connector. See Sensor - Ambient Air Temperature - Heating/Cooling Circuit (Remove and Replace).
  3. Connect the RH and LH accelerometer sensor connectors (x2).
  4. Connect the LH and RH front end carrier harness connectors (x2).
  5. Connect the active grille shutter actuator electrical connector.
  6. Connect the hood latch connector.
  7. Connect the hood latch actuator connector.
  8. Connect the LV battery. See LV Power (Modify).
  9. Install the HEPA filter or cowl assembly. See HEPA Filter Assembly (Remove and Replace) or Cowl Assembly (Model Y Standard) (Remove and Replace).