2026-01-07

Crush Can - Front Subframe - LH (Remove and Replace)

Correction code 1001030042 FRT 0.90 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-01-07: Released new procedure.

Torque Specifications

Table 1. Torque Specifications: Crush Can - Front Subframe - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the LH front subframe crush can to the vehicle
53 Nm (39.1 lbs-ft)
  • Socket 3/8in Dr. 6pt. Std. x 15mm
 Reuse

Remove

  1. Remove the ankle catcher. See Front Energy Absorber - Ankle Catcher (Remove and Replace).
  2. Remove the bolts (x2) that attach the LH front subframe crush can to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Socket 3/8in Dr. 6pt. Std. x 15mm
  3. Slightly pull the front end carrier away from the vehicle, then slide the LH front subframe crush can out of the front subframe.

Install

  1. Slightly pull the front end carrier away from the vehicle, then slide the LH front subframe crush can into the front subframe.
    Informational PurposesAn informational icon, calling your attention
    Note
    The arrow on the crush can is oriented toward the outside of the vehicle,
  2. Install the bolts (x2) that attach the LH front subframe crush can to the vehicle.
    53 Nm (39.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Socket 3/8in Dr. 6pt. Std. x 15mm
  3. Install the ankle catcher. See Front Energy Absorber - Ankle Catcher (Remove and Replace).