2025-03-18

ASY,HARN,GLASS,LHD,MY,EC (Remove and Replace)

Correction code 1710090102 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  1. 2025-03-18: Added steps to disconnect and connect the LV power to prevent part damage.

Remove

  1. Disconnect the LV battery power. See LV Power (Disconnect and Connect).
  2. Remove the upper camera cover assembly. See QUAD CAM CVR UPR (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the interior camera from the upper camera cover.
  3. Disconnect the GPS/GNSS antenna connector.
  4. Disconnect the forward facing camera connectors (x2).
  5. Disconnect the humidity and temperature sensor electrical connector.
  6. Release the hook that attaches the windshield harness to the windshield bracket.
  7. Remove the RH sun visor. See SUN VISOR - LEFT HAND (Remove and Replace).
  8. Remove the RH A-pillar upper trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  9. Remove the RH A-pillar lower trim. See A PILLAR LOWER TRIM - LEFT HAND (Remove and Install).
  10. Disconnect the windshield harness electrical connectors (x3) at the lower A-pillar.
  11. Release the clips that attach the front center of the headliner to the body to gain access to the windshield harness.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to bend the headliner. Replace any damaged clips.
  12. Release the clips (x4) and hooks (x4) that attach the windshield harness to the RH A-pillar.
  13. Release the hooks (x6) that attach the windshield harness along the top portion of the windshield, and then remove the harness from the vehicle.

Install

  1. Install the windshield harness along the top portion of the windshield, and then fasten the hooks (x6) that attach the harness to the windshield.
  2. Fasten the clips (x4) and hooks (x4) that attach the windshield harness to the RH A-pillar.
  3. Connect the windshield harness electrical connectors (x3) at the lower A-pillar.
  4. Install the clips that attach the front center of the headliner to the body.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to bend the headliner. Replace any damaged clips.
  5. Install the RH A-pillar upper trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  6. Install the RH A-pillar lower trim. See A PILLAR LOWER TRIM - LEFT HAND (Remove and Install).
  7. Install the RH sun visor. See SUN VISOR - LEFT HAND (Remove and Replace).
  8. Install the hook that attaches the windshield harness to the windshield bracket.
  9. Connect the GPS/GNSS antenna connector.
  10. Connect the forward facing camera connectors (x2).
  11. Connect the humidity and temperature sensor electrical connector.
  12. Install the quad camera upper cover assembly. See QUAD CAM CVR UPR (Remove and Replace).
  13. Connect the LV battery power. See LV Power (Disconnect and Connect).