2026-01-27

NV36 7S SEATS - 3rd Row Seat Covers, Pads and Trims - 3rd Row Seat Covers and Pads - 3rd row - Outer B-cover - LH (RI)

Correction code 1309010701 1309010702 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-01-26: Released new procedure.
  1. Open all four doors
  2. Lower all four windows
  3. Open liftgate
  4. Remove trunk load floor from vehicle
  5. Move LH front seat forward
  6. Position 60 seat into easy entry mode
    Informational PurposesAn informational icon, calling your attention
    Note
    Press shoulder switch and push 60 seat forward to position into easy entry mode
  7. Move RH front seat forward
  8. Position 40 seat into easy entry mode
    Informational PurposesAn informational icon, calling your attention
    Note
    Press shoulder switch and push 40 seat forward to position into easy entry mode
  9. Remove 3rd row seat cushion and disconnect harness
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector, Pull LH and RH release lever under 3rd row seat cushion to release seat cushion
  10. Remove 3rd row LH seat cushion bolster
    Informational PurposesAn informational icon, calling your attention
    Note
    1x bolt, 11mm, 37 Nm, 1x location pin, 1x tab, Slide LH seat cushion bolster towards front of vehicle to remove
  11. Remove LH outer cover
    Informational PurposesAn informational icon, calling your attention
    Note
    1x clip, 1x tablift/pry front then rear to release cover, slightly recline seat forward for easy removal of rear clip, then push from rear to remove from inner cover.
  12. Install LH outer cover
    Informational PurposesAn informational icon, calling your attention
    Note
    1x clip, 1x TabInsert outer cover into position and engage rear clip, re-engage front tab of outer cover
  13. Install 3rd row LH seat cushion bolster
    Informational PurposesAn informational icon, calling your attention
    Note
    1x bolt, 11mm, 37 Nm, 1x location pin, 1x tab, Slide LH seat cushion bolster into seat frame complete
  14. Install 3rd row seat cushion and connect harness
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector, Secure 3rd row seat cushion into RH and LH latches
  15. Move 60 seat to original position
  16. Move LH front seat to original position
  17. Move 40 seat to original position
  18. Install trunk load floor onto vehicle
  19. Move RH front seat to original position
  20. Close liftgate
  21. Raise all four windows
    Informational PurposesAn informational icon, calling your attention
    Note
    Via LH front door switch
  22. Close all four doors
    Informational PurposesAn informational icon, calling your attention
    Note
    Unlatch doors before closing if necessary