HARNESS - HEADLINER (Remove and Replace)
Correction code
1710050102
FRT
0.95
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the front headliner. See FRONT HEADLINER (Remove and Install).
- Disconnect the front overhead console connector.
- Disconnect the front headliner microphone connectors (x2).
- Disconnect the front headliner map light connectors (x2).
-
Release the fir tree clips (x2), the clips (x22) and the tapes to remove the
headliner harness from the front headliner.
NotePartially lift the NVH cotton to loosen the front headliner harness. Be careful not to damage the NVH cotton.
Install
-
Secure the fir tree clips (x2), the clips (x22) and the tapes to install the
headliner harness to the front headliner.
NoteApply new tape as needed.
- Connect the front headliner map light connectors (x2).
- Connect the front headliner microphone connectors (x2).
- Connect the front overhead console connector.
- Install the front headliner. See FRONT HEADLINER (Remove and Install).