2025-03-12

HARNESS - HEADLINER - PREM (Remove and Replace)

Correction code 1710050202 FRT 0.95 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the front headliner. See FRONT HEADLINER (Remove and Install).
  2. Disconnect the front overhead console connector.
  3. Disconnect the front headliner speaker connectors (x2).
  4. Disconnect the front headliner microphone connectors (x2).
  5. Disconnect the front headliner map light connectors (x2).
  6. Release the fir tree clips (x2), the clips (x22) and the tapes to remove the headliner harness from the front headliner.
    Informational PurposesAn informational icon, calling your attention
    Note
    Partially lift the NVH cotton to loosen the front headliner harness. Be careful not to damage the NVH cotton.

Install

  1. Secure the fir tree clips (x2), the clips (x22) and the tapes to install the headliner harness to the front headliner.
    Informational PurposesAn informational icon, calling your attention
    Note
    Apply new tape as needed.
  2. Connect the front headliner map light connectors (x2).
  3. Connect the front headliner microphone connectors (x2).
  4. Connect the front headliner speaker connectors (x2).
  5. Connect the front overhead console connector.
  6. Install the front headliner. See FRONT HEADLINER (Remove and Install).