2025-09-12

Foam - Back Rest - Passenger Seat (Model YL) (Remove and Replace)

Correction code 13010702302 FRT 1.02 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.
Informational PurposesAn informational icon, calling your attention
Note
The 1st row RH seat back foam and heat pad cannot be replaced separately. They need to be replaced together.

Install

  1. Install a new 1st row RH seat back heat pad onto the new seat back foam.
  2. Rotate the seat back blower counter-clockwise to install it onto the seat.
  3. Install the 1st row RH seat back foam to the seat back cover, and then install the seat back assembly to the vehicle. See Cover - Seat Back - 1st Row - RH (6 Seat) (Remove and Replace).