Frunk Seal (Remove and Replace)
Correction code
1224010302
FRT
0.05
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.NOTE:
See Ergonomic Precautionsfor safe
and healthy working practices.
Remove
- Open the LH front door and lower the LH front window.
- Open the hood.
-
Release the frunk seal from the perimeter of the frunk tub, and then remove
the seal from the vehicle.
Install
-
Align the line on the frunk seal to the striker.
-
Install the frunk seal to the perimeter of the frunk tub.
- Close the hood.
- Raise the LH front window and close the LH front door.