2024-11-11

Trim - Side Repeater - LH (Remove and Replace)

Correction code 1740010502 FRT 0.1 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Apply protective tape to the LH front fender around the LH front side repeater.
  2. Use a plastic trim tool to remove the LH side repeater trim, and then remove the trim from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage other parts and vehicle paint.
    Informational PurposesAn informational icon, calling your attention
    Note
    Start from the rear edge of the trim and work toward.

Install

  1. Use IPA wipes to clean off adhesive around the LH side repeater trim. And allow 1 minute to dry.
  2. Peel the adhesive backing from the side repeater trim, align the rib trim to the LH side repeater, and then press the trim to the fender.
  3. Remove the protective tape from the LH fender around the LH front side repeater.
  4. Use IPA wipes to clean the side repeater and any remaining adhesive.