2025-03-12

WASHER HOSE (Remove and Install)

Correction code 1750010102 FRT 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  2. Disconnect the front camera washer hose.
  3. Release the clip that attaches the front camera hose to the washer reservoir.
  4. Remove the bolts (x3) that attach the washer reservoir to the front end carrier, and then move the reservoir aside.
    Informational PurposesAn informational icon, calling your attention
    Note
    Be careful not to spill washer fluid from the reservoir.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Place an empty container into the front storage area.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the container is clean and not contaminated.
  6. Open the washer reservoir cap.
  7. Pour the washer fluid out of the washer reservoir.
    Informational PurposesAn informational icon, calling your attention
    Note
    Be careful not to spill the washer fluid.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove as much fluid as possible from the reservoir.
  8. Remove the container from the vehicle.
  9. Disconnect the washer hose from the windshield washer pump.
    Informational PurposesAn informational icon, calling your attention
    Note
    Unlock the black tab to disconnect the hose.
  10. Disconnect the washer hose from the windshield washer reservoir.
    Informational PurposesAn informational icon, calling your attention
    Note
    Unlock the black tab to disconnect the hose.
  11. Release the clips (x4) that attach the washer hose to the body, and then remove the hose from the vehicle.

Install

  1. Route the washer hose to the body, and then install the clips (x4) that attach the washer hose to the body.
  2. Connect the washer hose to the windshield washer reservoir.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lock the black tab to connect the hose.
  3. Connect the washer hose to the windshield washer pump.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lock the black tab to connect the hose.
  4. Move the washer reservoir back to its original position, and then install the bolts (x3) that attach the washer reservoir to the front end carrier.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Fasten the clip that attaches the front camera hose to the washer reservoir.
  6. Connect the front camera washer hose.
  7. Fill the windshield washer reservoir with washer fluid.
  8. Close the washer reservoir cap.
  9. Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  10. Verify operation of the windshield wipers and washer.