STEERING COLUMN CONTROL MODULE (Remove and Install)
Correction code
3205010701
FRT
0.25
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolt that attaches the steering column control module to the steering column |
![]() 2.4 Nm (1.8 lbs-ft) |
|
Reuse |
Remove
- Open the LH front door and lower the LH front window.
- On the touchscreen, touch Save. , use the left scroll wheel to adjust the steering column to its fully outward and fully downward position, and then touch
- Remove the lower shroud of the steering wheel. See INSTRUMENT PANEL STEERING COLUMN SHROUD LOWER (Remove and Replace).
-
Remove and discard the
retaining clip from the steering column control module connector, and then
disconnect the electrical harness from the steering column control module
connector.
CAUTIONCheck for broken clip pieces on the connector, and remove if present.
-
Loosen the bolt that attaches the
steering column control module to the steering column, and then release the clip and
remove the module from the vehicle.
TIpUse of the following tool(s) is recommended:
- Torx T20 bit
Install
-
Carefully install the steering column
control module onto the steering column to install the clip, and then install the bolt
that attaches the module to the steering column.2.4 Nm (1.8 lbs-ft)NoteMake sure that the steering column control module is properly seated.TIpUse of the following tool(s) is recommended:
- Torx T20 bit
-
Install an orange plastic retaining
clip (1028053-00-A) into the electrical harness connector for the steering column
control module, and then connect the electrical harness to the steering column control
module connector.
NotePerform a push-pull-push test to make sure that the steering column control module electrical connector is seated properly.
- Install the lower shroud of the steering wheel. See INSTRUMENT PANEL STEERING COLUMN SHROUD LOWER (Remove and Replace).
- On the touchscreen, touch Save. , use the left scroll wheel to adjust the steering column back to its original position, and then touch
- Raise the LH front window and close the LH front door.