2025-03-12

Wiper Arm and Blade - Passenger (Remove and Replace)

Correction code 1750020202 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1058696-00-B - Wiper Arm Removal Tool

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the hood.
  3. Release the RH wiper arm hose nozzle.
  4. Remove the RH wiper arm nut cover.
  5. Remove the RH wiper arm nut.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm socket
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
  6. Use the wiper arm removal tool (1058696-00-B) to remove the RH wiper arm and blade assembly from the vehicle.

Install

  1. Position the RH wiper arm and blade assembly onto the vehicle. Make sure the wiper tip is aligned between the two indicators at corner of windshield.
  2. Install the RH wiper arm nut.
    25 Nm (18.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm socket
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
  3. Install the RH wiper arm nut cover.
  4. Install the RH wiper arm hose nozzle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to route the hose below the RH wiper arm.
  5. Close the hood.
  6. Raise the LH front window and close the LH front door.