INNER BELT SEAL - REAR DOOR - LEFT HAND (Remove and Replace)
Correction code
1170040102
FRT
0.10
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).
- Release the clips (x6) that attach the rear and front of the inner belt seal to the rear door, and then pull up to release the inner belt seal.
Install
- Press the LH rear door inner belt seal downwards into the LH rear door.
- Install the clips (x6) that attach the inner belt seal to the LH rear door.
- Install the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).