2024-12-24

CloseOut - Center Console (Remove and Replace)

Correction code TBD FRT 0.55 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: CloseOut - Center Console (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that secures the center console closeout assembly to the center console
1.2 Nm (.9 lbs-ft)
  • Torx T20 bit
  • Torque wrench with angle measurement
Reuse

Remove

  1. Remove the puddle light. See Puddle Lamp - Center Console (Remove and Replace).
  2. Remove the screw that secures the center console closeout assembly to the center console.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Torque wrench with angle measurement
  3. Release the tabs (x4) that attach the closeout to the center console, and then remove the closeout from the vehicle.

Install

  1. Install the tabs (x4) that attach the closeout to the center console.
  2. Install the screw that secures the center console closeout assembly to the center console.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Torque wrench with angle measurement
  3. Install the puddle light. See Puddle Lamp - Center Console (Remove and Replace).