2026-08-09

Striker - Liftgate (Remove and Replace)

Correction code 1120020202 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Equipment:
  • 1588903-00-A Body Gap and Flush Tool

Torque Specifications

Table 1. Torque Specifications: Striker - Liftgate (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the liftgate striker to the body
24 Nm (17.7 lbs-ft)
  • Torx T45 socket
  • Flex head ratchet/flex head torque wrench
Reuse

Remove

  1. Remove the rear trunk sill trim. See Trunk Sill Lower Trim (Remove and Replace).
  2. Use masking tape to mark the location of the liftgate striker.
  3. Remove the bolts (x2) that attach the liftgate striker to the body, and then remove the striker from the vehicle.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T45 socket
    • Flex head ratchet/flex head torque wrench

Install

  1. Align the liftgate striker with the masking tape on the body, and then hand-tighten the bolts that attach the liftgate striker to the body.
  2. Close the liftgate and check gap/flush.
  3. Open the liftgate and adjust the striker position as necessary.
  4. Repeat step 2 and step 3 until alignment is satisfactory.
  5. Install the bolts (x2) that attach the liftgate striker to the body.
    24 Nm (17.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T45 socket
    • Flex head ratchet/flex head torque wrench
  6. Remove the masking tape around the liftgate striker.
  7. Install the rear trunk sill trim. See .