2025-03-12

Aero Shield - Middle (Remove and Replace)

Correction code 1203020102 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Aero Shield - Middle (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x11) that attach the mid aero shield panel to the vehicle
5 Nm (3.7 lbs-ft)
  • 10 mm socket
  • 4 in extension
  • Ratchet/torque wrench
Reuse

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Stands.
  2. Remove the push clips (x2) located at the LH and RH of the wheel house liner.
  3. Remove the bolts (x11) and tabs (x2) that attach the mid aero shield panel to the vehicle, and then remove the panel from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
    • Ratchet/torque wrench

Install

  1. Apply a thin bead of threadlocker to the threads of the bolts that attach the mid aero shield panel to the vehicle.
  2. Install the mid aero shield panel to the underside of the vehicle, and then install the bolts (x11) that attach the panel to the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
    • Ratchet/torque wrench
  3. Install the push clips (x2) located at the LH and RH of the wheel house liner.
  4. Remove the vehicle from the lift. See Raise Vehicle - 2 Stands.