2024-12-24

Hinge - Armrest - Center Console (Remove and Replace)

Correction code TBD FRT 0.55 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the center console armrest assembly. See 2.5 CONSOLE - ARMREST (Remove and Replace).
  2. Release the clips that attach the inner armrest to the outer armrest.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a trim tool and start from the top of the armrest to release the clips, then work towards the bottom.
  3. Remove the screws (x4) that attach the armrest hinge to the outer armrest, then remove the armrest hinge from the outer armrest.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Torque wrench with angle measurement

Install

  1. Position the armrest hinge to the outer armrest, and then install the screws (x4) that attach the armrest hinge to the outer armrest.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Torque wrench with angle measurement
  2. Align the locator pins, and then engage the clips that attach the inner armrest to the outer armrest.
  3. Install the center console armrest assembly. See 2.5 CONSOLE - ARMREST (Remove and Replace).