2025-04-22

Bolt Cover - Door Trim - Rear - LH (Remove and Replace)

Correction code TBD FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Bolt Cover - Door Trim - Rear - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the LH rear door bolt cover to the door
6 Nm (4.4 lbs-ft)
  • Ratchet/torque wrench
  • 4 in extension
  • Torx T30 socket
 Reuse

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Remove the bolt that attaches the LH rear door bolt cover to the door.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • 4 in extension
    • Torx T30 socket
  3. Release the clips (x9) that attach the bolt cover to the door assembly, and then release the tabs (x2) that attach the light to the bolt cover to remove the cover from the vehicle.

Install

  1. Install the tabs (x2) that attach the light to the bolt cove, and then install the clips (x9) that attach the bolt cover to the door assembly.
  2. Install the bolt that attaches the LH rear door bolt cover to the door.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • 4 in extension
    • Torx T30 socket
  3. Raise the LH rear window and close the LH rear door.