Blower - Backrest - Front Seat - LH (Remove and Replace)
Correction code
1301021002
FRT
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the driver seat back shell. See Shell - Seat Back - 1st Row (Remove and Replace).
- Disconnect the electrical connector from the driver seat back blower.
- Rotate the seat back blower clockwise to remove it from the seat.
Install
- Rotate the seat back blower counter-clockwise to install it onto the seat.
- Connect the electrical connector to the driver seat back blower.
- Install the driver seat back shell. See Shell - Seat Back - 1st Row (Remove and Replace).