2026-08-14

Assembly - Tail Lamp - Liftgate (Model Y L) (Remove and Replace)

Correction code 17401800002 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-08-14: Due to part changes, removed the liftgate camera and handle steps and added liftgate extension harness steps.

Torque Specifications

Table 1. Torque Specifications: Assembly - Tail Lamp - Liftgate (Model Y L) (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x4) that attach the lamp to the liftgate
4 Nm (2.9 lbs-ft)
  • Torx T30 socket
 Reuse
Nuts (x2) that attach the lamp to the liftgate
5 Nm (3.7 lbs-ft)
  • 10 mm deep socket
 Reuse
Bolts (x3) that attach the lamp to the liftgate
3.5 Nm (2.6 lbs-ft)
  • 10 mm deep socket
 Reuse

Replace

  1. Install the tail lamp assembly to the liftgate. See Assembly - Tail Lamp - Liftgate (Model Y L) (Remove and Install).
  2. Place the vehicle in Service Mode by using the touchscreen. See Service Mode.
  3. Unlock the vehicle gateway. See Gateway (Unlock).
  4. On the touchscreen, tap the Service Mode "wrench" (at the bottom of the touchscreen UI), and then tap Driver Assist > Cameras > Clear Camera Calibration, select RearView in the Camera Selection drop list, click Run, and allow the routine to complete.
  5. Tap Driver Assist > Cameras > Update Camera, select BACKUP, click Run, and allow the routine to complete.
  6. Exit Service Mode. See Service Mode.
  7. Raise the LH front window and close the LH front door.
  8. Inform the customer that the vehicle needs to be driven by the customer to complete the calibration procedure.