2025-09-29

Center Console - Armrest Assembly (Remove and Replace)

Correction code 1519021002 FRT 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Center Console - Armrest Assembly (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x6) that attach the armrest to the center console
1.2 Nm (.9 lbs-ft)
  • Torx T20 socket
 Reuse
Screws (x2) that attach the armrest to the center console
1.2 Nm (.9 lbs-ft)
  • Torx T20 socket
 Reuse

Remove

  1. Remove the rear end module assembly. See Module - Rear End - Center Console (Remove and Install).
  2. Remove the screws (x6) that attach the armrest to the center console.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  3. Remove the screws (x2) that attach the armrest to the center console.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. Remove the armrest from the center console.

Install

  1. Position the armrest to the center console.
  2. Install the screws (x6) that attach the armrest to the center console.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  3. Remove the screws (x2) that attach the armrest to the center console.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. Install the rear end module assembly. See Module - Rear End - Center Console (Remove and Install).