2024-11-11

Brake Shield - Front - LH (Dual Motor) (Remove and Replace)

Correction code TBD FRT 0.4 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Brake Shield - Front - LH (Dual Motor) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x3) that attach the LH front brake shield to the knuckle
8 Nm (5.9 lbs-ft)
  • Torx T30 socket
  • Torque wrench with angle measurement
Reuse

Remove

  1. Remove the LH front hub. See DRIVEN HUB 142MM FLANGE (Remove and Replace).
  2. Remove the bolts (x3) that attach the LH front brake shield to the knuckle, and then remove the brake shield from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Torque wrench with angle measurement

Install

  1. Install the bolts (x3) that attach the LH front brake shield to the knuckle.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Torque wrench with angle measurement
  2. Install the LH front hub. See DRIVEN HUB 142MM FLANGE (Remove and Replace).