2026-08-09

Audio Speaker - Rear - Headliner - LH (Model YL) (Remove and Replace)

Correction code 15200201302 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-08-07: Removed the steps to remove/install the C-pillar trim panel.

Torque Specifications

Table 1. Torque Specifications: Audio Speaker - Rear - Headliner - LH (Model YL) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the LH rear coat hook to the headliner
2.5 Nm (1.8 lbs-ft)
  • Torx T25 socket
 Reuse
Bolts (x2) that attach the LH rear headliner audio speaker to the headliner
0.65 Nm (6 lbs-in)
  • Torx T10 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
 Reuse

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Move the LH 2nd row seat forward.
    Note
    Adjust the seat back if needed.
  3. Open the liftgate.
  4. Fold the 3rd row seatback down.
    Note
    Protect the seat back upholstery from any potential scratch or damage.
  5. Remove the rear headliner. See Rear Headliner (Model YL) (Remove and Replace).
  6. Partially release the clips (x2) and location pin that attach the rear center area of the headliner to the body.
  7. Insert an inflatable airbag to support the LH rear section of the headliner for enough space to access the fasteners, and inflate the airbag..
    Note
    Take care not to damage the headliner.
  8. Disconnect the LH rear headliner audio speaker connector.
  9. Remove the bolts (x2) that attach the LH rear headliner audio speaker to the headliner, and then release the datums (x2) to remove the speaker from the vehicle.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm

Replace

  1. Align the datums (x2) to install the speaker to the vehicle, and then install the bolts (x2) that attach the LH rear headliner audio speaker to the headliner.
    0.65 Nm (6 lbs-in)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  2. Connect the LH rear headliner audio speaker connector.
  3. Deflate the inflatable airbag, and then remove it from the vehicle.
  4. Partially secure the clips (x2) and location pin that attach the rear center area of the headliner to the body.
  5. Install the rear headliner. See Rear Headliner (Model YL) (Remove and Replace).
  6. Move the 3rd row seatback back to its original position.
  7. Partially install the seal at the rear center of the headliner.
  8. Close the liftgate.
  9. Move the LH 2nd row seat back to its original position.
  10. Raise the LH rear window and close the LH rear door.