2025-03-12

REAR T - BADGE (Remove and Replace)

Correction code 1205010702 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1453028-00-A KIT, BADGE REMOVAL
  • 2142051-00-A REAR LETTERING JIG

Remove

Informational PurposesAn informational icon, calling your attention
Note
The badge cannot be reinstalled if removed. If the badge is removed for any reason, it must be replaced with a new part.
  1. Prepare the badge removal tool with approximately 60 centimeters of monofilament line.
  2. Tie slip knots at both ends of the monofilament line and attach them each to the center groove of a handle.
  3. Insert the monofilament line between the rear Tesla badge and the liftgate.
  4. Move the badge removal tool in a sawing motion to separate the rear Tesla badge from the liftgate.
  5. Use IPA wipes to clean all adhesive residue and debris from the liftgate surface.
  6. Release the clips (x2) that attach the liftgate handle to the liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not pull the handle too far from the vehicle, as the handle is still attached by an electrical connector.
  7. Use the masking tape to attach the liftgate handle to the liftgate, as the image shown:
    Informational PurposesAn informational icon, calling your attention
    Note
    This is to make sure sufficient working area for badge installation.

Install

  1. Align the pins (x2), and then install the rear badge fixture to the liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    Attach the fixture in place with tape.
    Informational PurposesAn informational icon, calling your attention
    Note
    The alignment pin position may differ by regions.
  2. Slowly peel the adhesive backing from the rear Tesla badge, align the badge protective film to the locating posts of the fixture, and then press the badge to the liftgate.
  3. Remove the protective film from the badge, and then remove the fixture from the liftgate.
  4. Replace the protective film over the badge, use a pressure roller to wet-out the badge, and then remove the protective film.
  5. Use an IPA wipe to clean the badge and any remaining debris.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that all edges of the badge are securely affixed to the liftgate surface.
  6. Remove the masking tape that attaches the liftgate handle to the liftgate.
  7. Install the clips (x2) that attach the liftgate handle to the liftgate.
  8. Use an IPA wipe to clean the liftgate and handle and any remaining debris.