HVAC - Thermistor Evaporator (Remove and Replace)
Correction code
1810011002
FRT
0.10
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Remove the LH console front side panel. See Side Panel - Front - Center Console - LH (Remove and Replace).
-
Disconnect the evaporator thermistor electrical connector.
-
Pinch the tabs (x2) on both sides and
pull the evaporator thermistor out from the HVAC assembly.
Install
-
Push the evaporator thermistor into
the HVAC assembly until the tabs (x2) are fully secure.
-
Connect the evaporator thermistor electrical connector.
- Install the LH console front side panel. See Side Panel - Front - Center Console - LH (Remove and Replace).