2026-08-09

Wiper Blades - Pair (Remove and Replace)

Correction code 1750010412 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. On the touchscreen, touch Controls > Service > Wiper Service Mode to enable Wiper Service Mode.
  2. Place a towel or shop rag underneath the wiper arms to prevent them from scratching the windshield.
  3. Pull up the wiper arm, depress the tab that attaches the LH wiper blade to the LH wiper arm, and then slide to remove the LH wiper blade from the wiper arm.
    CAUTION
    Pull up the wiper arm no more than 20 degrees. Over-pulling may damage the wiper arm.
    CAUTION
    Support the wiper arm and make sure that it does not directly contact the windshield.
  4. Repeat the previous step at the RH wiper arm.

Install

  1. Install the new LH wiper blade onto the LH wiper arm until the retaining tab is visible and an audible click is heard.
    CAUTION
    Pull up the wiper arm no more than 20 degrees. Over-pulling may damage the wiper arm.
  2. Repeat the previous step on the RH wiper arm.
  3. Remove the towel or shop rag from the windshield.
  4. On the touchscreen, touch Controls > Service > Wiper Service Mode to exit Wiper Service Mode.