2026-04-01

Liftgate Handle (Remove and Replace)

Correction code 1120010102 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-04-01: Updated the torque specs of the bolts securing the liftgate handle to the liftgate.
  • 2026-02-09: Clarified that the rear-facing camera does not need to be removed from the cover. Fixed incorrect link.

Torque Specifications

Table 1. Torque Specifications: Liftgate Handle (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the liftgate handle to the liftgate
1.5 Nm (1.1 lbs-ft)
  • BIT, T10 x 25mm
Reuse

Remove

  1. Remove the tuned mass damper. See Tuned Mass Damper (Remove and Replace).
  2. Remove the rear-facing camera cover from the liftgate. See Camera - Rear Facing (Remove and Install).
  3. Remove the bolts (x2) that attach the liftgate handle to the liftgate, and then remove the handle from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • BIT, T10 x 25mm

Install

  1. Position the handle and loosely install the bolts (x2) that attach the liftgate handle to the liftgate.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • BIT, T10 x 25mm
  2. Install the rear facing camera cover. See Camera - Rear Facing (Remove and Replace).
  3. Install the tuned mass damper. See Tuned Mass Damper (Remove and Replace).
  4. Close the liftgate to check gap/flush and, if necessary, perform adjustments.