Cover-Busbar - Shunt To Module 3 (Remove and Install)
Correction code
1630010601
FRT
2.22
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Lift PCS up and out of ancillary bay area and remove from vehicle. See Power Conversion System (Remove and Install).
-
Remove HV joint insulator for negative
busbar module 3 to shunt.
-
Remove negative busbar module 3 to
shunt cover.
Install
-
Install negative busbar module 3 to shunt cover.
-
Install HV joint insulator for negative busbar module 3 to shunt.
- Install the PCS assembly to vehicle. See Power Conversion System (Remove and Install).